They comprise of a go kart axle bearing attached to the body, a bicycle seat post clamp, some hardware, a few CNC bits and very soft skate bushes. The body bit is threaded plastic. The leg side is ali. The 4 long studs go through the bushes, allowing the kart bearing limited movement. The kart bearing also allows a little off axis movement and the bushes help allow that too. And they can be popped off if needed. :D
The 2nd set of holes allows the legs to be put on in 2 leg mode. Just in case. ;)
The blots shown here have now been replaced. But James earned that update. :)
No comments:
Post a Comment